![]() Netstat is useful in knowing some crucial information about your connection. To get the ARP table, you should enter the following in the command prompt and then press enter key: arp -a Netstat ![]() Using ARP command you can also detect if someone has poisoned your LAN. The arp command lets you simply know the arp table. If you don’t know the IP address of destination website, you can also use its domain name. For example, to see the hop table of an IP address enter the following: tracert x.x.x.x In addition to letting you know the hops, tracert also shows you exactly how much time it took at every hop when reaching the destination IP address. Tracert command lets you know how a packet will reach its destination. ![]() To see the routing table, enter the following in your command prompt: route print Tracert Route is an important command that shows you a routing table, gateway interfaces, and other important metrics. ipconfigĪlso, if you are using a dynamic IP address, you can change your IP address with following commands: ipconfig/release IPconfig shows you important information about your computer and your network, including DNS in use, your IP address, and your gateway etc. It is one of the best CMD commands used in hacking. This can also be replaced with a domain name, such as Ping IPconig Here, x.x.x.x is the IP address of destination computer. To use ping in the command prompt you use the following syntax: Ping x.x.x.x If there is no response from ping or there is an error, it is likely that either the destination computer is offline/malfunctioned or there is some problem with your network. It works by sending an ICMP echo request to the destination computer. One of the most common CMD command used in hacking, Ping simply checks if your computer can reach a specified computer or not. Once you have entered the above in the command prompt, you should see the IP address of website’s mail server on your screen. For example, to get the IP address of, you will have to enter the following in the CMD prompt: nslookup Aside from domain names of a website, nslookup can be used to find the IP address of an email server too, for example, to get the IP address of, you will have to enter the following: nslookup (press enter) Nslookup is a command that can find you the IP address of any website. Launching Command prompt with administrator privileges ![]()
0 Comments
Leave a Reply. |
Details
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |